To complete the picture – explain decoding equipment and the installation of more widespread HP DV6000
To complement this picture to explain the type of another device
It is also one of the most common devices in the Arab markets
HP DV6000
Picture of the number used
Also we used before removing any device you disconnect the power from the laptop remove the charger to the device and laptop battery by moving the private key and referred him the green arrow in Alsourh.obad that are removed all external nails and referred her red must
After that we will see a set screws down the device’s battery
After removing all external screws of the device is lifted following
Hard disk cover the
Memory cover the
Wi-Fi Pci – Cmos cover the
After that HDD is removed in this way (carefully and we drag attached to the outside)
And after all this is decrypted nails described the following image
Remove the WiFi card by raising the wire antenna and the card is then removed with ease
We come at this stage to remove the DNA in the device as de image
And then we can take it out in this way
Note that there are several screws bottom place Blackcurrant must remove
To get to this stage
We now turn to the upper part of the device
We Bazlh part that contains the operating key switches Almaltimdia of the device in this way, taking into account a number 2 Fallatah hyphen between this part and Almadhirbord private key operating private Balmaltamedia and each other
Then we can raise the keyboard in this way
And do not forget to raise your tape Balkibord this way
Followed by direct your mouse tape we also lifted
And also in the left of the device, we will find the key to your operating Fellata and Fallatah special Balmaltamedia we gently Brfhm
It does not remain only cable special device Speakerphone
Then move on to the decoding device screen by raising Fellata own in this way
Then it is decrypted screws on the screen of the device as shown in the picture
Also you’ll find on the other hand
After the lifting of the screen we unzip the rest of the nails with the lifting of the antenna wire and cable the camera Yellow
We disassemble the rest of nails described the chassis
Now we’ll unzip this part
Then we eminence as following form with the envisaged ban because this part is very weak
Then we Bazlh upper part like this
We Loosen the screws shown above
Then we brought in this way
We finally lifting Almadhirbord this way taking into account the cable shown above
And take into account the lifting of the other side
Then this wire is lifted
We turn next to decode the laptop screen
After removing all the screws in the image
We unzip your screen cover as shown
From the top
From the other side
From the bottom
To that we remove the cover this way
Then we raise the Alhaatenchen
LCD Almsaal for a lighting process and often find bottom of the screen if they are of a kind
Proving the screen from the inside several screws in the hinges
On the other side
And also
When you lift the screen shows us its own Fellata from behind
It is this section conclude these basics:
It’s when removing any device that we must therefore
– Raise the battery and remove the charger
– Decoding all the screws on the bottom of the machine and keep them into account sizes and forms and the places where they are installed out.
– Raise the part is installed, the power switch and that of the device
– HDD output, DVDs
– Raise the keyboard
– Untangle all the screws on the top of the device, which are located beneath the keyboard
– Raise the screen after decoding nails affiliate Filataat of Fallatah screen and Allowaarles Cable and Cable found that the camera
– Raise the upper part of the device
– Almadhirbord and edit them out
Hence, we have made this particular removing and installing the laptop in all its details the door and we hope to be successful in clarifying all the points that help novices in decoding any device
It’s when removing any device that we must therefore
– Raise the battery and remove the charger
– Decoding all the screws on the bottom of the machine and keep them into account sizes and forms and the places where they are installed out.
– Raise the part is installed, the power switch and that of the device
– HDD output, DVDs
– Raise the keyboard
– Untangle all the screws on the top of the device, which are located beneath the keyboard
– Raise the screen after decoding nails affiliate Filataat of Fallatah screen and Allowaarles Cable and Cable found that the camera
– Raise the upper part of the device
– Almadhirbord and edit them out
Hence, we have made this particular removing and installing the laptop in all its details the door and we hope to be successful in clarifying all the points that help novices in decoding any device